How to make a simple drill press jig with your drill press that will make it fast and easy to get perfectly vertical holes every time.. I have bought that same drill guide a couple years ago. my wife wanted a gin and tonic rail on our deck. i had 10 post 3 1/2" x 3 1/2" that i needed to drill 2 - 1" holes to feed in the 1" copper pipe through to make the top two rails. i made a jig out of 1/4" plywood with the two holes drilled at. You could get around the jig, and just clamp or force the joint tight, and drill an angle hole, with a combo countersink/pilot bit. use the correct screw length..
I've recently aquired several bf of white oak, that has been face planed, but not straight lined. i found this link for a simple jig, http://www.popularmechanics.com/home/reviews/4283497 just. This jig is an economical alternative to expensive drilling devices and confusing jigs this simple tool quickly locates drill center points for all brands of hinges and mounti. Check out david radtke’s shop-made drill press table plans. this diy woodworking project will add tons of versatility to your drill press..
0 komentar:
Posting Komentar